Kia Cadenza YG: Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Specifications
| Specification |
| Item | Specification |
| Control type | N/L (Normal Low) |
| Control pressure kpa(kgf/cm², psi) | "9.81 ~ 500.14(0.1 ~ 5.1, 1.42 ~ 72.54)" |
| Current value (mA) | 50 ~ 850 |
| Coil resistance(Ω) | 5.1 ± 0.3 |
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A).
Component Location 1. 26 Brake control solenoid valve (26/B_VFS)
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Height Sensor Repair procedures
Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Diagnosis With GDS 1. BSD system defects can be quickly diagnosed with the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis. 2. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, turn the power on GDS.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Body (Interior and Exterior)
- Transaxle Control Module (TCM) Repair procedures
- Timing Chain Repair procedures
- New on site
- Most important about car
