Kia Cadenza YG: Auto Lighting Control System / Auto Light Switch Repair procedures
Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Switch Repair procedures
| Inspection |
Lighting Switch Inspection
With the multi function switch in each position, make sure
that continuity exists between the terminals below. If continuity is not
as specified, replace the multi-function switch.
Lighting Switch (Auto Light)
Circuit Diagram
Inspection In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor''s input.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Heater Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/ recycling/ charging station. 3. When the engine is cool, drain the engine coolant from the radiator. 4. Remove the expansion valve cover (A).
Kia Cadenza YG 2016-2021 Service Manual: Auto defoging actuator Repair procedures
Inspection 1. Ignition "OFF”. 2. Disconnect the connector of auto defog control actuator. 3. Verify that the auto defog control actuator operates to the defrost ON mode when connecting 12V to the terminal 3 and grounding terminal 7. 4.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Driveshaft and axle
- Body Electrical System
- Restraint
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0323