| Component Location |

| 1. Driver power window switch 2. Door lock switch 3. IPM(Intelligent intergrated Platform Module) 4. Front door lock actuator | 5. Rear door lock actuator 6. Trunk lid open actuator 7. Assit power window switch |
Inspection Front Door Lock Actuator Inspection 1. Remove the front door trim. (Refer to Body - "Front Door") 2. Remove the front door module.
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace faulty tube or hose. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten joint of bolt or nut to specified torque.
Inspection 1. Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch. DisplayFail description00Normal23Auto defog sensor OPEN24Auto defog sensor SHORT43Defog door potentiometer OPEN/SHORT44Defog door potentiometer * Diagnostic procedure refer to DTC code.