Kia Cadenza YG: Engine Control System / Crankshaft Position Sensor (CKPS) Description and Operation
Kia Cadenza YG 2016-2021 Service Manual / Engine Control / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Description and Operation
| Description |
Crankshaft Position Sensor (CKPS) detects the crankshaft
position and is one of the most important sensors of the engine control
system. If there is no CKPS signal input, the engine may stop because of
CKPS signal missing. This sensor is installed on the cylinder block or
the transaxle housing and generates alternating current by magnetic flux
field which is made by the sensor and the target wheel when engine
runs.
The target wheel consists of 58 slots and 2 missing slots on 360 degrees CA (Crank Angle).
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the ECTS connector. 3. Remove the ECTS (Refer to "Removal"). 4. After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4.
Specification ItemSpecificationCoil Resistance (Ω)500 ~ 620 [20°C(68°F)]
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Adaptive Front Lighting System Description and Operation
Description AFLS Unit(ECU) AFLS located in Cockpit Module is provided information of vehicle (steering wheel signal,vehicle speed, inclination of vehicle). Based on provided information , it calculates algorithm and adjust Low beam of H/Lamp. It transmits driving information by using LIN protocol, it is operated in Fail-safe reaction mode
Kia Cadenza YG 2016-2021 Service Manual: Components and Components Location
C
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Suspension System
- Automatic Transaxle System
- Timing Chain Repair procedures
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0196