Kia Cadenza YG: Ignition System / Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Engine Electrical System / Ignition System / Description and Operation

Description
Ignition timing is controlled by the electronic control ignition timing system.
The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module).
The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM.
The ignition coil is activated, and timing is controlled.

    On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.     • If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Surround View Monitoring Switch Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover. (Refer to Body - "Floor Console Assembly") 3. Disconnect the console upper cover connector (A). 4. Remove the cup holder assembly (A) after loosening the mounting screws.

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0335