Kia Cadenza YG: Fuel Delivery System / Fuel Pressure Sensor (FPS) Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pressure Sensor (FPS) Description and Operation

Description
The fuel pressure sensor (FPS) is installed on the top of the low pressure fuel pump and measures the pressure in the low pressure fuel line.
Based on the fuel pressure measured by the FPS and the amount of fuel consumed, the fuel pump control module (FPCM) determines whether to activate the low pressure fuel pump.
After activating the low pressure fuel pump, the FPS continues to provide the fuel pressure information to the FPCM and the FPCM keeps controlling the fuel flow rate using the feedback information from the FPS.

    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. Remove the fuel pump control module mounting bolts (A).

    Specification Pressure [KPa (kgf/cm², psi)]Output Voltage (V)50 (0.51, 7.3)0.3600 (6.12, 87.0)2.51100 (11.2, 159.5)4.51200 (12.2, 174.0)5

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Parking Assist Sensor Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") 3. Disconnect the connector (A) from the parking assist sensor. 4. Pull out the sensor (A) by opening the sensor holder (B) out.

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Switch Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the passenger compartment junction box cover. 3. Remove the driver side cover (A). 4. Remove the crash pad side switch assembly (A) by pushing it through side cover hole.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0243