Kia Cadenza YG: Lighting System / Head Lamps Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Lighting System / Head Lamps Description and Operation

HID Head Lamp
1.
Bulb
(1)
Elements
Xenon gas: Xenon gas activates the initial reaction for rapid illuminating.
Molybdenum electrode: anode arcing
Metal halide salts: color composing component
(2)
Lightening principle
When Xenon gas and metal halide salt will discharge the molybdenum anode in a capsule, it emits light.
2.
Ignitor
Ignitor (A) is an electromagnetic transformer that receives current from ballast and boost voltage to light on the arc light source in any environment.

3.
Ballast
(1)
Ballast (A) delivers an instant high voltage pulse to the ignitor electrode, to initialize discharge in the source.
(2)
Ballast supplies the stable power to the bulb and the ignitor during initialization and normal state of arc.

4.
Stability
(1)
Durable for vibration as there is no filament.
(2)
Does not operate if polarity are changed.
(3)
Doesn''t operate if the input voltage is not in the range of 10-16V.
(4)
Doesn''t operate if the circuit is short.
(5)
Doesn''t operate if the bulb burnt out.

    Component 1. Head lamp assembly lens & housing2. Head lamp high beam bulb3. Dust cap (High)4. Head lamp low beam bulb5. Dust cap (Low)6. Turn signal lamp socket7.

    Inspection 1. Check-points upon head lamp failure (HID) (1) Check the battery voltage. (Low beam will be on when the battery voltage above 9V.) (2) Check the fuse and relay.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Repair procedures

    Inspection Initialization and diagnosis sequence by using diagnostic equipment Below content summarize the procedure for A/S using Diagnostic equipment Download Parameter 1. Select "AFLS" menu after selecting a vehicle. 2. Select "Parameter download" menu for define a characteristc of vehicle.

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0275