Kia Cadenza YG: Lubrication System / Oil Filter Body Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Engine Mechanical System / Lubrication System / Oil Filter Body Repair procedures

Removal and Installation
1.
Drain engine oil.
(Refer to Lubrication System - "Engine Oil")
2.
Remove the water center pipe.
(Refer to Cooling System - "Water Temperature Control Assembly")
3.
Wait for 5 minutes after loosening the oil filter cap to drain well the oil in the oil filter.
4.
Remove the oil filter body (A).
Tightening torque:
9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

   
•
All rubber gaskets must not be damaged by assembling parts.
•
Do not reuse oil filter body O-ring.
5.
Install in the reverse order of removal.
6.
Start engine and check for oil leaks.
7.
Recheck the engine oil level.

    Components 1. Oil filter body2. Gasket

    Components 1. Upper oil pan2. Lower oil pan3. Drain plug4. Drain plug gasket

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Kia Cadenza YG 2016-2021 Service Manual: Climate Control Air Filtar Repair procedures

    Replacement 1. Disconnect the damper (B) from the glove box (A) and then remove the glove box lift (C). 2. Remove the filter cover (A) with pushing the knob. 3. Replace the air filter (B), install it after making sure of the direction of air filter.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.019