Kia Cadenza YG: Automatic Transaxle Control System / Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).

4.
Measure the resistance between power terminal (10) and signal terminal (7).
Specification : 5.1 ± 0.3 Ω

Replacement
   
If a solenoid valve of VFS type needs to be replaced, the valve body assembly should be replaced and the oil pressure should be adjusted. If the solenoid valve is replaced individually, it is not possible to adjust the oil pressure without additional equipment, and if the oil pressure adjustment procedure is not performed, a shift shock or delay may occur.
1.
Replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body")

    Circuit Diagram

    Specification Item SpecificationControl typeN/H (Normal High)Control pressure kpa (kgf/cm², psi)500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)Current value (mA) 50 ~ 850Coil resistance(Ω)5.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Auto defoging sensor Repair procedures

    Inspection 1. Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch. DisplayFail description00Normal23Auto defog sensor OPEN24Auto defog sensor SHORT43Defog door potentiometer OPEN/SHORT44Defog door potentiometer * Diagnostic procedure refer to DTC code.

    Kia Cadenza YG 2016-2021 Service Manual: Heater Unit Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/ recycling/ charging station. 3. When the engine is cool, drain the engine coolant from the radiator. 4. Remove the expansion valve cover (A).

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0273