| Inspection |
| 1. |
Remove the front door quadrant delta cover.
(Refer to Body - "Front Door") |
| 2. |
Disconnect the power door mirror connector from the harness.
|
| 3. |
Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.
Mirror Heater Inspection
Puddle Lamp
ECM
Side Repeater Lamp
Folding Mirror
|
Inspection 1. The DDM inputs can be checked using the GDS. 2. To check the input value of door lock switch, select option "IPM". 3. Select option "DDM (Driver Door Module)".
Removal Front Pantoscopic Camera 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") 3. Remove the pantocscpic camera (B) after loosening the mounting screws and connector (A).
Inspection Self diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code. After the display panel flickers three times every 0.5 second, the corresponding fault code flickers on the setup temperature display panel every 0.