Kia Cadenza YG: Crankcase Emission Control System / Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Emission Control System / Crankcase Emission Control System / Repair procedures

Inspection
1.
After disconnecting the vapor hose from the PCV valve, remove the PCV valve.
2.
Reconnect the PCV valve to the vapor hose.
3.
Inspect the PCV vlave operation.
(1)
Run the engine at idle.
(2)
Put a finger on the open end of the PCV valve.
(3)
Make sure that intake manifold vaccum can be felt.
   
The plunger inside the PCV valve will move back and forth at vacuum.

4.
If the vacuum is not felt, clean or replace the vapor hose.

    Schematic Diagram

    Operation Principle

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Immobilizer Control Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.

    Kia Cadenza YG 2016-2021 Service Manual: Compressor Repair procedures

    Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. 3. Recover the refrigerant with a recovery/charging station.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0351