Kia Cadenza YG: Automatic Transaxle Control System / Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Repair procedures

Adjustment
Transaxle Control Module(TCM) Learning
When shift shock is occurred or parts related with the transaxle are replaced, TCM learning should be performed.
In the following case, TCM learning is required.
•
Transaxle assembly replacement
•
TCM replacement
•
TCM upgrading
TCM learning procedure
1.
ATF temperature: 40~100°C (104~212°F)
2.
Static learning
Repeat the below shift pattern four times or more with stepping on the brake.

3.
Driving learning
Drive the vehicle from a stop in D through all gears 1st, 2nd, 3rd, 4th, 5th and 6th gear while holding the throttle steady at the specified TPS value (15~25%).

    Description Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values.

    Circuit Diagram

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Adaptive Front Lighting System Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the crash pad side cover (A). [RH] 3. Disconnect the stopper (B) from the glove box (A). 4. Disconnect the air damper (A) from the glove box (B).

    Kia Cadenza YG 2016-2021 Service Manual: Mode Control Actuator Repair procedures

    Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.019