Kia Cadenza YG: Automatic Transaxle Control System / Shift Lever Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Lever Repair procedures

Removal
1.
Remove the center console assembly.
(Refer to Body - "Floor console")
2.
Remove the air duct (A).

3.
Disconnect the shift cable (A) and then remove the shift cable (B) after pressing the shift cable socket (C) in the direction of "F".

   
Installating method for shift cable lever side
•
Install the cable socket part to the lever assembly securely after adjusting the wings (A) of cable socket part upward.
•
Install the cable socket part to the lever assembly securely after adjusting the projection (B) to prevent wrong assembly upward.

4.
Shift lever assembly connector (A).

5.
Remove the shift lever assembly (A) by removing the bolts (4ea).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Inspection
1.
Check the damage and operation of the control cable.
2.
Check the damage of the boot.
3.
Check the damage and corrosion of the bushing.
4.
Check the damage or weakening of the spring.
Installation
1.
Installation is the reverse of removal.
   
Set room side lever and T/M side lever to "N" position.

    Components 1. Shift lever knob & Boots assembly2. Shift lever assembly 3. Control cable assembly

    Components 1. Shift lever knob & Boots assembly2. Shift lever assembly3. Control cable assembly

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Specifications

    Specification Air Conditioner ItemSpecificationCompressorType6VSX16Oil type & CapacityPAG OIL 100±10Pulley type6PK-TYPEDisplacement160cc/revCondenserHeat rejection14,400 ±5% kcal/hrA/C Pressure transducerThe method to measure the pressureVoltage= 0.

    Kia Cadenza YG 2016-2021 Service Manual: Compressor Components and Components Location

    C

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0276