Kia Cadenza YG: Airbag Module / Side Airbag (SAB) Module Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Restraint / Airbag Module / Side Airbag (SAB) Module Description and Operation

Description
The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag by using Side Impact Sensor (SIS) signal.
   
Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury.

    Removal 1. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. 2. Remove the glove box housing. (Refer to Body - "Glove box housing") 3.

    Components

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Repair procedures

    Inspection Tolerance Calibration Tolerance calibration compensates for the error margins of surround view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance calibration if you do any of the following.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Components and Components Location

    Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0279