Kia Cadenza YG: SRSCM / Side Impact Sensor (SIS) Description and Operation
Kia Cadenza YG 2016-2021 Service Manual / Restraint / SRSCM / Side Impact Sensor (SIS) Description and Operation
| Description |
Side Impact Sensor (SIS) system consists of two P-SIS which
are installed at each center of the front door module (LH and RH) and
two SIS which are installed at each rear pillar nearby (LH and RH).
Side Pressure Sensor is also called P-SIS because it detects pressure due to collision at its mounting location.
Side Impact Sensor is also called A-SIS because it detects acceleration.
SRSCM decides deployment of the airbag and the time of
deployment through the collision signal of the SIS when the collision
occurred.
Removal • Removal of the airbag must be performed according to the precautions/ procedures described previously.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Auto Head lamp leveling Unit Repair procedures
Removal Height Sensor 1. Remove the height sensor connector (A). 2. Loosen the mounting bolts(Body: 2EA, chassis: 1EA) from height sensor bracket. Tightening torque : 3 ~ 5N.m (30 ~ 50kgf.m, 2.21 ~ 3.68lb-ft) 3. Remove the height sensor.
Kia Cadenza YG 2016-2021 Service Manual: Power Mosfet Repair procedures
Inspection 1. Ignition "ON" 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed. Specification FanMotor VoltageManualFirst speed3.8 ±0.5VSecond speed5.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Schematic Diagrams
- Schematic Diagrams
- Brake System
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0225