Kia Cadenza YG: Restraint / Special Service Tools
| Special Service Tools |
| Tool(Number and Name) | Illustration | Use |
| Deployment tool 0957A-34100A |
| Airbag deployment tool. |
| Deployment adapter 0957A-3F100 |
| Use with deployment tool. (SAB) |
| Deployment adapter 0957A-3Q100 |
| Use with deployment tool. (DAB, PAB, CAB, BPT, EFD) |
| Dummy 0957A-38200 |
| Simulator to check the resistance of each wiring harness. |
| Dummy adapter 0957A-3F000 |
| Use with dummy (SAB) |
| Dummy adapter 0957A-2G000 |
| Use with dummy (DAB, PAB, CAB, BPT, EFD) |
Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp for a LED lamp check.
Component Replacement After Deployment Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Kia Cadenza YG 2016-2021 Service Manual: Blower Resistor Repair procedures
Inspection 1. Measure terminal - to - terminal resistance of blower resistor. 2. If measure resistance isnot within specification, the blower resistor must be replaced. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower cover (A) and then disconnect the connector (B).
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Mode Control Actuator Repair procedures
- Front Hub - Axle Repair procedures
- Front Bumper Repair procedures
- New on site
- Most important about car
