Kia Cadenza YG: Multifunction switch / Specifications
Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Multifunction switch / Specifications
| Specifications |
| Items | Specifications | |
| Rated voltage | DC 12V | |
| Operating temperature range | -30°C ~ +80°C (-22 ~ +176°F) | |
| Rated load | Dimmer & passing switch | High : 0.2A (Relay load) Low : 0.2A (Relay load) Passing : 0.2A (Relay load) |
| Lighting switch / Auto lighting switch | Lighting : 0.2A (Relay load) | |
| Turn signal & lane change switch | 6.6 A | |
| Front & rear fog lamp switch | 0.2A (Relay load) | |
| Wiper & mist switch | Low, High : 4.5A (Motor load) Auto : 0.22 ± 0.05A (Relay load) Lock : Max. 28A (Motor load) | |
| Washer switch | 4A (Motor load) | |
| Variable intermittent volume switch | Max. 25mA | |
Component (1) 1. Steering column2. Lighting switch3. Wiper switch4. Screw5. Steering angle sensor6. Clock spring Component (2)
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Height Sensor Repair procedures
Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B). Installation 1. Install the back view camera and camera holder.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Emission Control System
- Body (Interior and Exterior)
- Suspension System
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0213