| Specifications |
| Item | Specification |
| Rating voltage | DC 12V |
| Operating voltage | DC 9V ~ 16V |
| Operating temperature | -30°C ~ +80°C |
| Maintaining temperature | -40°C ~ +85°C |
| Max, humid | 95% |
| Consumption current | MAX 700mA |
| Dark current | Below 2mA |
| Item | Specification |
| Rating voltage | 13.5V (Slide, Recline, Front height, Rear height) |
| Current | Slide : 8A |
| Recline : 8A | |
| Front height : 7.5A | |
| Rear height : 7.5A | |
| At worst current | Slide : 24A |
| Recline : 20A | |
| Front height : 25A | |
| Rear height : 27A |
| Mechanical System |
| Item | Specification |
| Type | Motor with hall IC |
| Duty ratio | 50 ± 15 |
| Total stroke | Slide : 240mm |
| Recline : 63° | |
| Front height : 32mm (Motor) | |
| Rear height : 52mm (Motor) | |
| Total pulse number | Slide : 899 |
| Recline : 1,136 | |
| Front height : 333 | |
| Rear height : 412 | |
| Moving speed (Terminal voltage : 13.5V) | Slide (Forward) : 17.9 mm /sec or more, Slide (Backward) : 20.2 mm /sec or more |
| Recline : 3.5 °/ sec | |
| Front height : 7 mm / sec or more | |
| Rear height : 7 mm / sec or more |
Component Location 1. Seat Memory Unit (IMS)2. IMS control switch3. IMS driver power seat control
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw.
Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compressor.