| Component Location |

| 1. Seat Memory Unit (IMS) 2. IMS control switch | 3. IMS driver power seat control |
Specifications IMS Electrical System ItemSpecificationRating voltageDC 12VOperating voltageDC 9V ~ 16VOperating temperature-30°C ~ +80°CMaintaining temperature-40°C ~ +85°CMax, humid95%Consumption currentMAX 700mADark currentBelow 2mA Motor Electrical System ItemSpecificationRating voltage13.
Circuit Diagram Input/Output Specification Connector Pin Lay Out IMS input/output pin information NoSignal NameI/OContentsRemarkA1---A2FR height motor upOFR height motor up outputA3RR height motor upORR height motor up outputA4Recline motor FRORecline motor FR outputA5Slide motor FROSlide motor FR outputA6---A7FR height motor downOFR height motor down outputA8---A9---A10RR height motor downORR height motor down outputA11Recline motor RRORecline motor RR outputA12Slide motor RROSlide motor RR outputB1GND(Power)IPower B+ for operating motorB2GND (Power)IPower GND for operating motorB3B+(Power)IPower B+ for operating motorB4---B5GND (Power)IPower GND for operating motorC1---C2---C3Slide FR manual switchISlide FR manual switch inputOn : GNDC4Recline FR manual switchIRecline FR manual switch inputOn : GNDC5FR height up manual switchIFR height up manual switch inputOn : GNDC6RR height up manual switchIRR height up manual switch inputOn : GNDC7Slide motor sensorISlide motor sensor inputPulse signalC8Recline motor sensorIRecline motor sensor inputPulse signalC9FR height motor sensorIFR height motor sensor inputPulse signalC10Sensor Vcc(Seat)OVCC for operating sensor5VC11---C12---C13Slide RR manual switchISlide RR manual switch inputON : GNDC14Recline RR manual switchIRecline RR manual switch inputON : GNDC15FR height down manual switchI FR height down manual switch inputON : GNDC16RR height down manual switch- RR height down manual switch inputON : GNDC17---C18---C19---C20---D1---D2RR height up sensorIRR height up motor sensorPulse signalD3---D4CAN highI/OCAND5CAN lowI/OCAND6---D7IGN1IIGN1 inputBATD8B+(ECU)IECU power inputBATD9GND(ECU)IECU GNDD10---D11---D12---D13---D14---D15---D16--- Communication System
Specification ItemSpecificationUltrasonic sensorVoltage ratingDC 12 VDetecting range30 cm ~ 120 cmOperation voltageDC 9 ~ 16 VOperation currentMAX 300 mAOperation temperature-30°C ~ +80°C (-22°C ~ +176°C)Operation frequency48 ± 5 KHzEffective operating velocity10 KPH (6.
Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B). Installation 1. Install the back view camera and camera holder.