| Specification |
| Item | Type | Wattage (W) | ||
| Front | Head lamp (High) | H9 | 65 | |
| Head lamp (Low) | H7/ D1S (HID) | 55/ 35(HID) | ||
| Front turn signal lamp | PY28/8 | 28W | ||
| Position lamp | LED | LED | ||
| Side repeater lamp (Outside mirror) | LED | LED | ||
| Front fog lamp | General | H8 | 35 | |
| LED | LED | LED | ||
| Rear | Stop and tail lamp | LED | LED | |
| Rear turn signal lamp | PY27 | 27W | ||
| Back-up lamp | W16W | 16 | ||
| High mounted stop lamp | LED | LED | ||
| License plate lamp | W5W | 5W | ||
| Interior | Overhead console lamp | Deluxe | LED | LED |
| General | W10W | 10W | ||
| Room lamp | FESTOON | 5 | ||
| Trunk lamp | FESTOON | 5 | ||
| Vanity lamp | FESTOON | 5 | ||
Component Location (1) 1. Head lamp (Low)2. Head lamp (High)3. Position lamp4. Turn signal lamp5. DRL6. Fog lamp7. Overhead console lamp (General/ Panorama roof)8.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw.
Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B). Installation 1. Install the back view camera and camera holder.