Kia Cadenza YG: MTS System / Telemetics Unit (TMU) Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / MTS System / Telemetics Unit (TMU) Repair procedures

Removal
   
•
Take care not to scratch the crash pad and related parts.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the AVN monitor.
(Refer to "AVN System" - "AVN Head Unit")
3.
Remove the TMU unit (A) after loosening the mounting screws.

4.
Disconnect the connectors (A) from the TMU unit.

Installation
1.
Install the TMU unit after connecting the connector.
2.
Install the AVN monitor.
3.
Connect the negative (-) battery terminal.
Inspection
1.
After replacing the TMU unit, access Dealer Engineering Mode in head unit.
(Refer to MTS system - "TMU Dealer Engineering Mode")
2.
Check the TMU version ("App S/W") from the head unit screen.

3.
Check the H/U Type from the head unit screen.

4.
Check the Model from the head unit screen.

    Component Connector Pin Specification No.Pin NameTypeFromToDescription (Wiring Spec.)1GNDDC GroundTMUBatteryConnected to battery ground2GNDDC GroundTMUBatteryConnected to battery ground3-----4-----5-----6-----7-----8-----9-----10-----11-----12HS CAN (-)Data I/OBUSBUSHigh Speed CAN bus low13HS CAN (+)Data I/OBUSBUSHigh Speed CAN bus high14-----15-----16-----17-----18V battery 1DC InputBatteryTMUDC level input from battery Supply power to TMU19Ignition 1Data InputJunction BoxTMUVehicle Key mode status20ACCData InputJunction BoxTMUVehicle Key mode status21AirbagData InputACUTMUAirbag status data from ACU22-----23-----24-----25-----26-----27-----28-----29-----30-----31MM CAN (-)Data I/OBUSBUSLow Speed CAN bus low32MM CAN (+)Data I/OBUSBUSLow Speed CAN bus high

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Mode Control Actuator Repair procedures

    Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.     Make sure that there is no air leaking out of the blower and duct joints.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0188