Kia Cadenza YG: Cylinder Block / Water Jacket Seperator Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Engine Mechanical System / Cylinder Block / Water Jacket Seperator Repair procedures

Removal
1.
Remove the LH/RH cylinder head assembly and gasket.
(Refer to Cylinder Head Assembly - "Cylinder Head")
2.
Remove the water jacket seperators (A).

Installation
1.
Install the #1, #2 cylinder bore water jacket seperators (A).

   
Insert the seperator align with block inner side protrusion, and it must be located under the cylinder head installing surface.

2.
Install the LH/RH cylinder head assembly and gasket.
(Refer to Cylinder Head Assembly - "Cylinder Head")

    Components 1. Water jacket separator

    Components 1. Drive plate2. Adapter plate

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Radar Calibration Description and Operation

    Description To sense the cars exactly in the next lane with the radar, the direction of the sensor and the direction of the vehicle have to align. This is BSD unit alignment. If this alignment is not performed as below illustration, the degradation of detection performance and the cause of false alarms.

    Kia Cadenza YG 2016-2021 Service Manual: Heater Unit Components and Components Location

    Component Location Components 1. Heater Case (LH)2. Separator3. Evaporator Core4. Shower Duct (LH)5. Heater Core Cover6. Heater Core7. Mode Actuator8. Mode Cam9. Temp Actuator (Drive)10. Vent Door Arm11. Floor Door Arm 1. Heater Case (RH)2.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0339