Kia Cadenza YG: Cooling System / Water pump Troubleshooting

Troubleshooting
Symptoms
Possible Causes
Remedy
Coolant leakage
•
From the bleed hole of the water pump
Visually check
•
Check leaks after about ten-minute warming up.
•
If coolant still leaks, replace a water pump.
•
If leakage stops, reuse the water pump (Do not replace the pump with a new one).
•
From gaskets or bolts
•
Check the tightening of the water pump mounting bolts.
•
Retighten the mounting bolts.
•
Check damage of gaskets or inflow of dust.
•
Replace the gasket and clean dust off.
•
From outer surface of water pump
•
Check the material or any cracks of the water pump.
•
Poor material. If any crack found, replace the water pump.
Noise
•
From bearings
•
From mechanical seals
•
Impeller interference
Inspection with a stethoscope
•
After starting the engine, check noise with a stethoscope.
•
If there is no noise, reuse the water pump(do not replace it).
•
If there is any noise from the water pump, remove the drive belt and recheck.
Inspection after removing a drive belt
•
After removing a water pump and a drive belt, check noise again.
•
If there is noise, reuse the water pump. Check other drive line parts.
•
If there is no noise, replace the water pump with a new one.
Inspection after removing a water pump
•
After removing a water pump and a drive belt, check noise again.
•
If there is any interference between them, replace the water pump with a new one.
Overheating
•
Damaged impeller
•
Loosened impeller
Loosened impeller
•
Corrosion of the impeller wing
•
Check engine coolant.
•
Poor coolant quality / Maintenance check
•
Impeller seperation from the shaft
•
Replace the water pump.

    Removal 1. Remove the engine room under cover. (Refer to Engine And Transaxle Assembly - "Engine Room Under Cover") 2. Drain the coolant. (Refer to Cooling System - "Coolant") 3.

    Components 1. Water temperature control assembly2. Thermostat3. Water inlet fitting pipe

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Antenna Coil Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw.

    Kia Cadenza YG 2016-2021 Service Manual: Mode Control Actuator Repair procedures

    Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0356