Kia Cadenza YG: Engine Mechanical System / Cooling System
- Components and Components Location
- Troubleshooting
- Coolant Repair procedures
- Cooling Fan Components and Components Location
- Cooling Fan Description and Operation
- Cooling Fan Specifications
- Cooling Fan Schematic Diagrams
- Cooling Fan Repair procedures
- Radiator Components and Components Location
- Radiator Repair procedures
- Reservoir Tank Repair procedures
- Water Temperature Control Assembly Components and Components Location
- Water Temperature Control Assembly Repair procedures
- Water pump Components and Components Location
- Water pump Repair procedures
- Water pump Troubleshooting
- Thermostat Components and Components Location
- Thermostat Repair procedures
- Thermostat Troubleshooting
Disassembly • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion.
Components 1. Cooling fan2. Cooling fan motor3. Cooling fan shroud4. Resistor5. Radiator assembly 6. Mounting insulator 7. Radiator upper hose8. Radiator lower hose9.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Inspection Tolerance Calibration Tolerance calibration compensates for the error margins of surround view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance calibration if you do any of the following.
Kia Cadenza YG 2016-2021 Service Manual: Antenna Coil Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Rail Pressure Sensor (RPS) Schematic Diagrams
- Automatic Transaxle System
- Engine Control / Fuel System
- New on site
- Most important about car
