Kia Cadenza YG: Cooling System / Reservoir Tank Repair procedures
| Removal and Installation |
| 1. |
Disconnect the over flow hose (A), and then remove the resorvior tank (B).
|
| 2. |
Installation is in the reverse order of removal. |
| 3. |
Fill the reservoir tank to the "F" line with coolant.
|
Removal and Installaton 1. Remove the engine room under cover. (Refer to Engine And Transaxle Assembly - “Engine Room Under Cover”) 2. Drain the coolant.
Components 1. Water pipe 2. Throttle body coolant hose & pipe3. Water temperature control assembly4. O-ring
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Inspection Initialization and diagnosis sequence by using diagnostic equipment Below content summarize the procedure for A/S using Diagnostic equipment Download Parameter 1. Select "AFLS" menu after selecting a vehicle. 2. Select "Parameter download" menu for define a characteristc of vehicle.
Kia Cadenza YG 2016-2021 Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. 3. Recover the refrigerant with a recovery/charging station.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Steering System
- Driveshaft and axle
- Rail Pressure Sensor (RPS) Schematic Diagrams
- New on site
- Most important about car
