Kia Cadenza YG: Cooling System / Water Temperature Control Assembly Components and Components Location
| Components |
| 1. Water pipe 2. Throttle body coolant hose & pipe | 3. Water temperature control assembly 4. O-ring |
Removal and Installation 1. Disconnect the over flow hose (A), and then remove the resorvior tank (B). Tightening torque: 3.9 ~ 5.9 N.m (0.4 ~ 0.
Removal and Installation • To avoid damage, unplug the wiring connectors carefully while holding the connector portion.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Height Sensor Repair procedures
Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.
Kia Cadenza YG 2016-2021 Service Manual: Refrigerant line Repair procedures
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace faulty tube or hose. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten joint of bolt or nut to specified torque.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Mode Control Actuator Repair procedures
- Rail Pressure Sensor (RPS) Schematic Diagrams
- Emission Control System
- New on site
- Most important about car
