Kia Cadenza YG: Cooling System / Radiator Components and Components Location
| Components |
| 1. Radiator 2. Mounting insulator 3. Radiator upper hose 4. Radiator lower hose | 5. Coolant reservoir tank 6. Over flow hose 7. ATF cooler hose |
Removal and Installaton Cooling Fan Assembly 1. Disconnect the battery negative terminal. 2. Remove the air duct (A). 3. 3. Loosen the upper hose fixing bolt (A), and disconnect the fan motor connector (B).
Removal and Installaton 1. Remove the engine room under cover. (Refer to Engine And Transaxle Assembly - “Engine Room Under Cover”) 2. Drain the coolant.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with an PCM(ECM) request for vehicle specific data (PIN code: 6digits) from the tester.
Kia Cadenza YG 2016-2021 Service Manual: Receiver-Drier Repair procedures
Replacement 1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser. Tightening torque : 9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8 lb-ft) 2. Remove the desiccant (A) from condenser using a long nose plier.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Emission Control System
- Schematic Diagrams
- Driveshaft and axle
- New on site
- Most important about car
