Kia Cadenza YG: Windshield Deicer / Windshield Deicer Repair procedures
| Inspection |
| 1. |
Remove the cowl top cover. (Refer to the wiper) |
| 2. |
Disconnect the windshield deicer connector (A) from the wiper motor linkage.
|
| 3. |
Check for continuity between the terminals of deicer lines.
|
| 4. |
Turn the ignition switch ON and the windshield deicer switch
ON, then measure the voltage between the terminals of harness side
deicer connector.
|
Description Windshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay.
Inspection 1. The windshield deicer switch inputs can be checked using the GDS. 2. To check the input value of windshield deicer switch, select option "IPM".
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Immobilizer Control Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.
Kia Cadenza YG 2016-2021 Service Manual: Compressor Oil Repair procedures
Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compressor.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Emission Control System
- Engine Control / Fuel System
- Alternator Schematic Diagrams
- New on site
- Most important about car
