Kia Cadenza YG: Heater / Mode Control Actuator Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Heating,Ventilation, Air Conditioning / Heater / Mode Control Actuator Repair procedures

Inspection
1.
Ignition "OFF”
2.
Disconnect the connector of mode control actuator.
3.
Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7.
4.
Verify that the mode control actuator operates to the vent mode when connecting in the reverse.

1. -
2. -
3. Defrost mode
4. Sensor ground
5. Feedback signal
6. 5V(Vcc)
7. Vent mode

5.
Check the voltage between terminals 4 and 5.
Specification
Door position
Voltage(4-5)
Error detecting
Max. cooling
0.3 ± 0.15V
Low voltage :0.1V or less
Max. heating
4.7 ± 0.15V
High voltage :4.9V or more

It will feedback current position of actuator to controls.
6.
If the measured voltage is not specification, substitute with a known-good mode control actuator and check for proper operation.
7.
If the problem is corrected, replace the mode control actuator.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad left side cover (A).

3.
Remove the console side cover [LH].
(Refer to BD group – "Console")
4.
Remove the crash pad lower cover (A) by loosening the mounting screws.

5.
Disconnect the diagnosis connector (A) and then remove the crash pad lower cover.

6.
Remove the left shower duct (A).

7.
Remove the BCM(A) by loosening the mounting bolt and nut.

8.
Disconnect the mode control actuator connector (A).
9.
Loosen the mounting screw and then remove the mode control actuator (B).

10.
Installation is the reverse order of removal.

    Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit.

    Component Location

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Specifications

    Specification Air Conditioner ItemSpecificationCompressorType6VSX16Oil type & CapacityPAG OIL 100±10Pulley type6PK-TYPEDisplacement160cc/revCondenserHeat rejection14,400 ±5% kcal/hrA/C Pressure transducerThe method to measure the pressureVoltage= 0.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Motor Repair procedures

    Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for proper operation. 3. If the problem is corrected, replace the blower motor.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0264