Kia Cadenza: Lubrication System / Oil Pump Repair procedures

Kia Cadenza YG 2016-2025 Service Manual / Engine Mechanical System / Lubrication System / Oil Pump Repair procedures

Removal and Installation

1.	Remove the lower oil pan. (Refer to Lubrication System - "Oil Pan")

Remove the oil pump chain cover (A).

Tightening torque :

9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

Remove the bolt (A) and then seperate the chain with sprocket from the oil pump.

Tightening torque :

18.6 ~ 21.6N.m (1.9 ~ 2.2kgf.m, 13.7 ~ 15.9lb-ft)

Remove the oil pump (A).

Tightening torque :

20.6 ~ 22.6N.m (2.1 ~ 2.3kgf.m, 15.2 ~ 16.6lb-ft)

When installing, use a new O-ring.

5.	Install in the reverse order of removal.

6.	After assembly, wait at least 30 minutes before filling the engine with oil.

Oil Pump Components and Components Location

Components 1. Oil pump2. O-ring3. Oil pump sprocket4. Oil pump chain cover ...

Oil Pressure Switch Components and Components Location

Components 1. Oil cover2. Oil cover gasket3. Oil pressure switch ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: Schematic Diagrams

System Block Diagram Component Parts And Function Outline Component partFunctionVehicle-speed sensorConverts vehicle speed to pulse.ECMReceives signals from sensor and control switches.Cruise control indicatorIlluminate when CRUISE main switch is ON (Built into cluster)Cruise Control switchesC ...

Kia Cadenza YG 2016-2025 Service Manual: Knock Sensor (KS) Repair procedures

Removal [Knock Sensor #1 (Bank 1)] 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the knock sensor connector (A). 3. Remove the intake manifold. (Refer to Engine Mechanical System - "Intake Manifold") 4. Remove the installation bolt ...