Kia Cadenza YG: Engine Mechanical System / Lubrication System
- Flow Diagram
- Engine Oil Repair procedures
- Oil Filter Body Components and Components Location
- Oil Filter Body Repair procedures
- Oil Pan Components and Components Location
- Oil Pan Repair procedures
- Oil Pump Components and Components Location
- Oil Pump Repair procedures
- Oil Pressure Switch Components and Components Location
- Oil Pressure Switch Repair procedures
- Oil Level Gauge & Pipe Components and Components Location
- Oil Level Gauge & Pipe Repair procedures
Troubleshooting SymptomsPossible CausesRemedyCoolant leakage • From the thermostat gasket Check the mounting bolts • Check the torque of the mounting bolts • Retighten the bolts and check leakage again.
Engine oil flow diagram
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B). Installation 1. Install the back view camera and camera holder.
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws. Make sure that there is no air leaking out of the blower and duct joints.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Control / Fuel System
- Schematic Diagrams
- Brake System
- New on site
- Most important about car
