Kia Cadenza: Towing / Removable towing hook
.jpg)
1. Open the trunk, and remove the
towing hook from the tool case.
2. Remove the hole cover pressing
the upper part of the cover on the
bumper.
3. Install the towing hook by turning it
clockwise into the hole until it is
fully secured.
4. Remove the towing hook and
install the cover after use.
If emergency towing is necessary,
we recommend having it done by an
authorized Kia dealer or a commercial
tow-truck service. Proper lifting
and towing procedures are necessary
to prevent d ...
If towing is necessary, we recommend
you to have it done by an
authorized Kia dealer or a commercial
tow truck service.
If towing service is not available in an
emergency, your vehicle may ...
Other information:
Removal and Installation
1.
Remove the engine room front under cover (A) and the side covers (B).
When removing the under covers (B), unfasten the mounting
bracket bolts and then remove the under cover and mounting bracket
assembly.
2.
Install in the reve ...
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the floor console.
(Refer to the Body - "Console")
3.
After removing the bolt (A), remove the rear vent duct (B).
4.
Disconnect the yaw rate & lateral G sensor connector (A).
5.
Rem ...