Kia Cadenza YG: SRSCM / Side Impact Sensor (SIS) Description and Operation
Kia Cadenza YG 2016-2021 Service Manual / Restraint / SRSCM / Side Impact Sensor (SIS) Description and Operation
| Description |
Side Impact Sensor (SIS) system consists of two P-SIS which
are installed at each center of the front door module (LH and RH) and
two SIS which are installed at each rear pillar nearby (LH and RH).
Side Pressure Sensor is also called P-SIS because it detects pressure due to collision at its mounting location.
Side Impact Sensor is also called A-SIS because it detects acceleration.
SRSCM decides deployment of the airbag and the time of
deployment through the collision signal of the SIS when the collision
occurred.
Removal • Removal of the airbag must be performed according to the precautions/ procedures described previously.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws. Make sure that there is no air leaking out of the blower and duct joints.
Kia Cadenza YG 2016-2021 Service Manual: Intake Actuator Description and Operation
D
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Automatic Transaxle System
- Transaxle Control Module (TCM) Repair procedures
- Engine Mechanical System
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0208