Kia Cadenza YG: Multifunction switch / Specifications
| Specifications |
| Items | Specifications | |
| Rated voltage | DC 12V | |
| Operating temperature range | -30°C ~ +80°C (-22 ~ +176°F) | |
| Rated load | Dimmer & passing switch | High : 0.2A (Relay load) Low : 0.2A (Relay load) Passing : 0.2A (Relay load) |
| Lighting switch / Auto lighting switch | Lighting : 0.2A (Relay load) | |
| Turn signal & lane change switch | 6.6 A | |
| Front & rear fog lamp switch | 0.2A (Relay load) | |
| Wiper & mist switch | Low, High : 4.5A (Motor load) Auto : 0.22 ± 0.05A (Relay load) Lock : Max. 28A (Motor load) | |
| Washer switch | 4A (Motor load) | |
| Variable intermittent volume switch | Max. 25mA | |
Component (1) 1. Steering column2. Lighting switch3. Wiper switch4. Screw5. Steering angle sensor6. Clock spring Component (2)
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Radar Calibration Description and Operation
Description To sense the cars exactly in the next lane with the radar, the direction of the sensor and the direction of the vehicle have to align. This is BSD unit alignment. If this alignment is not performed as below illustration, the degradation of detection performance and the cause of false alarms.
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws. Make sure that there is no air leaking out of the blower and duct joints.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Emission Control System
- Transaxle Control Module (TCM) Repair procedures
- Alternator Schematic Diagrams
- New on site
- Most important about car
