Kia Cadenza YG: Automatic Transaxle Control System / SS-B Solenoid Valve(ON/OFF) Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / SS-B Solenoid Valve(ON/OFF) Description and Operation

Description
•
SS-B solenoid valve is ON/OFF type.
•
When TCM supplies power to solenoid valve, speed range is changed by operating the solenoid valve.

SS-B Solenoid Valve operation table
　
SS-B
N, P

1

2

3
●
4
　
5
●
6
　
R
●

● : Connected status
Δ : Connected at vehicle speed above 8km/h

    Component Location 1. SS-B Solenoid Valve (ON/OFF)

    Circuit Diagram

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Components and Components Location

    Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.

    Categories

     
    Copyright © 2025 www.kcadenzavg.com - 0.018