Kia Cadenza: Rear Cross-Traffic Collision Warning (RCCW)/ Rear Cross-Traffic Collision-Avoidance Assist (RCCA) / Warning and control
Rear Cross-Traffic Collision Warning
.jpg)
If the vehicle detected by the rear corner radar sensors approaches from the rear left/right side of your vehicle, the warning chime will sound, the warning light on the outside rearview mirror will blink and a message will appear on the LCD display or Infotainment System screen If the rear view monitor system is in activation, a message will also appear on the Infotainment System screen.
When the operation condition of Rear Cross-Traffic Collision Warning is satisfied the warning will occur every time a vehicle approaches the side/rear of your stopped vehicle.
The warning will stop when:
- The vehicle moving at the rear
left/right side of your vehicle is not
in the detection range.
- The vehicle is right behind your
vehicle.
- The vehicle is not driving towards
your vehicle.
- The vehicle’s approaching speed is
decreased.
System setting and activation
System setting
The driver can activate the systems
by placing the ENGINE
START/STOP button to the ON
position and by selecting "Settings
> Vehicle > Driver Assistance >
Par ...
Rear Cross-Traffic Collision-Avoidance system
If the risk of collision is detected while RCCW is generated, brake is
controlled.
The instrument cluster will inform the driver of the brake control. If
the rear view monitor system is in act ...
Other information:
Kia Cadenza YG 2016-2023 Owners Manual: Washer fluid
Checking the washer fluid level The reservoir is translucent so that you can check the level with a quick visual inspection. Check the fluid level in the washer fluid reservoir and add fluid if necessary. Plain water may be used if washer fluid is not available. However, use washer ...
Kia Cadenza YG 2016-2023 Owners Manual: System Setting and Operation
System setting Reverse Parking Collision-Avoidance Assist can be activated from the Settings menu in the LCD display or infotainment system display by following the procedure below. 1. Set the Engine Start/Stop button to the ON or START position. 2. Select ‘Settings → Driver Assis ...
