| Components |

| 1. Water jacket separator |
Components 1. Piston ring2. Piston3. Connecting rod4. Connecting rod upper bearing5. Piston pin6. Connecting rod lower bearing7. Connecting rod bearing cap8.
Removal 1. Remove the LH/RH cylinder head assembly and gasket. (Refer to Cylinder Head Assembly - "Cylinder Head") 2. Remove the water jacket seperators (A).
Inspection 1. Ignition "OFF". 2. Disconnect evaporator temperature sensor. 3. Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor. Specification Evaporator coretemperature [°C(°F)]Resistance[KΩ]Voltage[V]-20(-4)70.
Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for proper operation. 3. If the problem is corrected, replace the blower motor.