Kia Cadenza YG: Body Electrical System / AVN System
- Specifications
- Components and Components Location
- Schematic Diagrams
- Description and Operation
- AVN Head Unit Components and Components Location
- AVN Head Unit Repair procedures
- Speaker Repair procedures
- Roof Antenna Repair procedures
- Steering Wheel Remote Controller (SWRC) Components and Components Location
- Steering Wheel Remote Controller (SWRC) Schematic Diagrams
- Steering Wheel Remote Controller (SWRC) Repair procedures
- Multimedia Jack Schematic Diagrams
- Multimedia Jack Description and Operation
- Multimedia Jack Repair procedures
Inspection Test the horn by connecting battery voltage to the 1 terminal and ground the 2 terminal. The horn should make a sound. If the horn fails to make a sound, replace it.
Specifications AVN Head Unit ItemSpecificationPower sourceDC 14.4V (-) groundFrequency range / Channel spaceFM : 87.5 ~ 107.9 MHz / 200 KHzAM : 530 ~ 1710 KHz / 10 KHzTuning typePLL SYNTHESIZED TUNINGImpedance2 ohm x 4Antenna80 pF 75 OhmDark currentMax.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Height Sensor Repair procedures
Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.
Kia Cadenza YG 2016-2021 Service Manual: Start/Stop Button Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screw driver or remover, remove the center fascia lower panel (A). 3. Remove the in-car hose (A) and disconnect the connectors (B) from the heater & A/C control unit. 4.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Electrical System
- Crankshaft Damper Pulley Components and Components Location
- Schematic Diagrams
- New on site
- Most important about car
