Kia Cadenza YG: Engine Mechanical System / Engine And Transmission Assembly
- Engine Cover Repair procedures
- Engine Room Under Cover Components and Components Location
- Engine Room Under Cover Repair procedures
- Engine Mounting Components and Components Location
- Engine Mounting Repair procedures
- Engine And Transmission Assembly Repair procedures
Troubleshooting SymptomSuspect areaRemedyEngine misfire with abnormal internal lower engine noises.Worn crankshaft bearings.Loose or damaged engine drive plate.
Removal and Installation 1. Remove the engine cover (A). • Lift up the lower end of engine cover, then left and right alternately.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Lane Departure Warning System (LDWS) Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the LDWS unit cover (A). 3. Remove the LDWS unit connector (A). 4. Remove the LDWS unit after widening the mounting clips. Installation 1. Install the LDWS unit. 2.
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Components and Components Location
Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Battery Troubleshooting
- General Information
- Components and Components Location
- New on site
- Most important about car
