Kia Cadenza: Seat / Front seat adjustment - power
The front seat can be adjusted by using the control switches located on the outside of the seat cushion. Before driving, adjust the seat to the proper position so you can easily control the steering wheel, pedals and switches on the instrument panel.
WARNING - Unattended children
Do not leave children unattended in the vehicle. Children might operate features of the vehicle that could injure them.
CAUTION - Power seat adjustments
The power seating controls function by electronic motor. Excessive operation may cause damage to the electrical equipment.
CAUTION - Power Seating
Do not operate two or more power seat control switches at the same time. Doing so may damage the power seat motor or electrical components.
When in operation, the power seatconsumes a large amount of electrical power. To prevent unnecessary system drain, don’t adjust the power seat longer than necessary while the engine is not running.
- Forward and backward
- Cushion extension (for driver's seat)
- Seatback angle
- Seat height
- Lumbar support
- Driver position memory system
- Storing positions into memory using the buttons on the door
- Easy access function
Feature of Seat Leather
Leather is made from the outer
skin of an animal, which goes
through a special process to be
available for use. Since it is a natural
substance, each part differs in
thickness or den ...
Forward and backward
Push the control switch forward or
backward to move the seat to the
desired position. When the control
switch is operated forward, the seat
cushion is slightly raised, and the
seat cushion ...
Other information:
Kia Cadenza YG 2016-2024 Service Manual: Rear Combination Lamp Repair procedures
Rear Combination Lamp (Outside) 1. Disconnect the negative (-) battery terminal. 2. If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (B) after removing the trim cover (A) in the trunk. 3. Remove the nuts (4EA). 4. Remove the r ...
Kia Cadenza YG 2016-2024 Service Manual: Positive Crankcase Ventilation (PCV) Valve Repair procedures
Removal 1. Disconnect the vapor hose (A). 2. Remove the PCV valve (B). Inspection 1. Insert a thin stick (A) into the PCV valve (B) from the threaded side to check that the plunger moves. If the plunger does not move (PCV valve is clogged), clean or replac ...
