Kia Cadenza YG: Heating,Ventilation, Air Conditioning / Heater
- Heater Unit Components and Components Location
- Heater Unit Repair procedures
- Temperature Control Actuator Components and Components Location
- Temperature Control Actuator Description and Operation
- Temperature Control Actuator Repair procedures
- Mode Control Actuator Components and Components Location
- Mode Control Actuator Description and Operation
- Mode Control Actuator Repair procedures
- Auto defoging actuator Components and Components Location
- Auto defoging actuator Repair procedures
Inspection 1. Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch. DisplayFail description00Normal50Cluster ionizer fault * Diagnostic procedure refer to DTC code.
Component Location Components 1. Heater Case (LH)2. Separator3. Evaporator Core4. Shower Duct (LH)5. Heater Core Cover6. Heater Core7. Mode Actuator8.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Mode Control Actuator Repair procedures
Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.
Kia Cadenza YG 2016-2021 Service Manual: Blower Resistor Repair procedures
Inspection 1. Measure terminal - to - terminal resistance of blower resistor. 2. If measure resistance isnot within specification, the blower resistor must be replaced. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower cover (A) and then disconnect the connector (B).
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Battery Troubleshooting
- General Information
- Schematic Diagrams
- New on site
- Most important about car
