Kia Cadenza YG: Automatic Transaxle Control System / Input Speed Sensor Description and Operation
Kia Cadenza YG 2016-2021 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor Description and Operation
| Description |
Input speed sensor is a vital unit that measures the rate of
rotation of the input shaft inside the transaxle and delivers the
readings to the Transaxle Control Module(TCM). The sensor provides
critical input data that''s used in feedback control, damper clutch
control, gear setting control, line pressure control, clutch activation
pressure control, and sensor fault analysis.
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A).
Specifications ▷ Type: Hall effect sensor Operation condition [°C(°F)]((-)40~150)) -40~302Air gap(mm)in.(0.95~1.65)0.037~0.065Output voltage(V)High1.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Components and Components Location
C
Kia Cadenza YG 2016-2021 Service Manual: Heater Unit Components and Components Location
Component Location Components 1. Heater Case (LH)2. Separator3. Evaporator Core4. Shower Duct (LH)5. Heater Core Cover6. Heater Core7. Mode Actuator8. Mode Cam9. Temp Actuator (Drive)10. Vent Door Arm11. Floor Door Arm 1. Heater Case (RH)2.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Schematic Diagrams
- Specifications
- Engine Mechanical System
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0193