Kia Cadenza YG: Engine Control System / Barometric Pressure Sensor (BPS) Specifications
| Specification |
| Pressure [kPa (kgf/cm², psi)] | Output Voltage (V) |
| 10.0 (0.01, 0.15) | 0.50 |
| 55.0 (0.56, 7.98) | 2.21 |
| 115.0 (1.17, 16.9) | 4.50 |
Description Barometric Pressure Sensor (BPS) is a speed-density type sensor and is installed on the air cleaner assemby. It senses absolute pressure of the air cleaner assemby and transfers the analog signal proportional to the pressure to the ECM.
Circuit Diagram
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Evaporator unit Repair procedures
Inspection 1. Ignition "OFF". 2. Disconnect evaporator temperature sensor. 3. Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor. Specification Evaporator coretemperature [°C(°F)]Resistance[KΩ]Voltage[V]-20(-4)70.
Kia Cadenza YG 2016-2021 Service Manual: Auto defoging sensor Repair procedures
Inspection 1. Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch. DisplayFail description00Normal23Auto defog sensor OPEN24Auto defog sensor SHORT43Defog door potentiometer OPEN/SHORT44Defog door potentiometer * Diagnostic procedure refer to DTC code.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Control / Fuel System
- Body (Interior and Exterior)
- Body Control Module (BCM) Description and Operation
- New on site
- Most important about car
