Kia Cadenza YG: Engine Control System / Heated Oxygen Sensor (HO2S) Specifications

Kia Cadenza YG 2016-2021 Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Specifications

Specification
A/F Ratio (λ)
Output Voltage(V)
RICH
Min. 0.8
LEAN
Max. 0.1

Item
Specification
Heater Resistance (Ω)
3.3 ~ 4.1[20°C(68°F)]

    Description Heated Oxygen Sensor (HO2S) consists of the zirconium and the alumina and is installed on upstream and downstream of the Warm-up Catalytic Converter (WCC).

    Wave Form

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Kia Cadenza YG 2016-2021 Service Manual: Auto defoging sensor Repair procedures

    Inspection 1. Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch. DisplayFail description00Normal23Auto defog sensor OPEN24Auto defog sensor SHORT43Defog door potentiometer OPEN/SHORT44Defog door potentiometer * Diagnostic procedure refer to DTC code.

    Categories

     
    Copyright © 2025 www.kcadenzavg.com - 0.0213