Kia Cadenza YG: Audio / Multimedia jack Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Audio / Multimedia jack Repair procedures

Removal
1.
Remove the shift lever knob.
(Refer to Body - "Console")
2.
Remove the floor console upper cover.
3.
Disconnect the connector (A) from the floor console upper cover.

4.
Remove the multimedia jack (B) from the console upper cover after releasing the fixed hooks (A).

Installation
1.
Install the multimedia jack.

2.
Install the floor console upper cover.
3.
Install the shift lever knob.
   
Make sure the multimedia connector and the console upper cover connectors are plugged in properly.

    Description The multimedia jack on the console upper cover is for customers who like to listen to external portable music players like the MP3, iPod and etc.

    Troubleshooting Customer Complaint Analysis Check Sheet There are six areas where a problem can occur: wiring harness, the radio, the CD player, and speaker.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Repair procedures

    Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with an PCM(ECM) request for vehicle specific data (PIN code: 6digits) from the tester.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Resistor Repair procedures

    Inspection 1. Measure terminal - to - terminal resistance of blower resistor. 2. If measure resistance isnot within specification, the blower resistor must be replaced. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower cover (A) and then disconnect the connector (B).

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0193