| Troubleshooting |
| Customer Complaint Analysis Check Sheet |


| Chart 1 |


| Chart 2 |

| Chart 3 |

| Chart 4 |




| Chart 5 |

| Chart 6 |

| Chart 7 |

Removal 1. Remove the shift lever knob. (Refer to Body - "Console") 2. Remove the floor console upper cover. 3. Disconnect the connector (A) from the floor console upper cover.
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with an PCM(ECM) request for vehicle specific data (PIN code: 6digits) from the tester.
Inspection 1. Ignition "OFF”. 2. Disconnect the connector of auto defog control actuator. 3. Verify that the auto defog control actuator operates to the defrost ON mode when connecting 12V to the terminal 3 and grounding terminal 7. 4.