Kia Cadenza YG: Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Restraint / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work.
2.
The seat belt emergency fastening device (A) be removed after pushing the lock pin (B) as arrow direction.

3.
Remove the door scuff trim.
(Refer to Body - "Door scuff trim")
4.
Remove the center pillar trim
(Refer to Body - "Center pillar trim")
5.
Remove the upper anchor bolt.
6.
Disconnect the seat belt pretensioner connector (C).

7.
Loosen the seat belt pretensioner mounting bolts (A,B) and remove the seat belt pretensioner.
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Install the seat belt pretensioner with a bolts (A,B).
Tightening torque
Bolt B: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Connect the seat belt pretensioner (BPT) connector (C).
5.
Install the upper anchor bolts.
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
6.
Install the center pillar trim
(Refer to Body - "Center pillar trim")
7.
Install the door scuff trim.
(Refer to Body - "Door scuff trim")
8.
Insert the seat belt to the anchor pretensioner (A).

   
Make sure the lock pin is connected in properly.
9.
Reconnect the battery negative cable.
10.
After installing the seat belt pretensioner, confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

    Components

    Description Emergency Fastening Device (EFD) operates as well as Belt Pretensioner at the same time If it gets into its deploy condition after a collision.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Auto Head lamp leveling Unit Repair procedures

    Removal Height Sensor 1. Remove the height sensor connector (A). 2. Loosen the mounting bolts(Body: 2EA, chassis: 1EA) from height sensor bracket. Tightening torque : 3 ~ 5N.m (30 ~ 50kgf.m, 2.21 ~ 3.68lb-ft) 3. Remove the height sensor.

    Kia Cadenza YG 2016-2021 Service Manual: Heater Unit Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/ recycling/ charging station. 3. When the engine is cool, drain the engine coolant from the radiator. 4. Remove the expansion valve cover (A).

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0225