Kia Cadenza YG: Automatic Transaxle Control System / Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Specifications
| Specification |
| Item | Specification |
| Control type | N/H (Normal High) |
| Control pressure kpa (kgf/cm², psi) | "500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)" |
| Current value (mA) | 50 ~ 850 |
| Coil resistance(Ω) | 5.1 ± 0.3 |
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A).
Component Location 1. Overdrive clutch control solenoid valve (OD/C_VFS)
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Description and Operation
Description System Operation Typically, lane departure warning is activated at a speed over 70 KPH, but suppressed in case of unintentional lane departure when driver do not operate turn signal. System Operation Conditions 1. User Conditions (1) When unintended lane departure is occured, warnings are generated.
Kia Cadenza YG 2016-2021 Service Manual: Receiver-Drier Repair procedures
Replacement 1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser. Tightening torque : 9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8 lb-ft) 2. Remove the desiccant (A) from condenser using a long nose plier.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Components and Components Location
- Suspension System
- Transaxle Control Module (TCM) Repair procedures
- New on site
- Most important about car
