Kia Cadenza YG: Body (Interior and Exterior) / Seat Belt
Replacement Seat Assembly Replacement 1. Remove the rear seat cushion (A). 2. Disconnect the rear seat cushion heater connectors (A). 3. After loosening the mounting bolts, then remove the rear seat back (A).
Components 1. Front seat belt2. Height adjuster3. Rear seat belt (RH)4. Rear center seat belt5. Rear seat belt (LH)6. Rear center seat belt buckle
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B). Installation 1. Install the back view camera and camera holder.
Kia Cadenza YG 2016-2021 Service Manual: Evaporator unit Repair procedures
Inspection 1. Ignition "OFF". 2. Disconnect evaporator temperature sensor. 3. Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor. Specification Evaporator coretemperature [°C(°F)]Resistance[KΩ]Voltage[V]-20(-4)70.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- General Information
- Timing Chain Repair procedures
- High Pressure Fuel Pump Repair procedures
- New on site
- Most important about car
