Kia Cadenza YG: Body Electrical System / Auto Lighting Control System
- Specifications
- Components and Components Location
- Schematic Diagrams
- Auto Light Switch Repair procedures
- Auto Light Sensor Repair procedures
Troubleshooting 1. The lamp switch inputs can be checked using the GDS. 2. To check the input value of lamp switch, select option "IPM". 3. To consult the present input/output value of IPM, "Current DATA".
Specifications ItemsSpecificationsRated voltageDC +5VLoadMax. 1mA (When head lamp lighting)IlluminationsTail lampON : 0.52 ± 0.03 (V)OFF : 1.58 ± 0.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Pantoscopic Camera Repair procedures
Removal Front Pantoscopic Camera 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") 3. Remove the pantocscpic camera (B) after loosening the mounting screws and connector (A).
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Components and Components Location
Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Body (Interior and Exterior)
- Specifications
- Timing Chain Repair procedures
- New on site
- Most important about car
